These lights come with a wired A19 bulb base that will screw into your existing can light receptacle. No transformer required.

The unit has a matte finish. The over is metal and pretty thick and sturdy. It's got a very minimal stipple on it. Looks very nice and classy.

Reverse phase dimming usually gives you better overall control and smooth dimming down to 5% light levels, while forward phase normally dims smoothly down to 10%. Generally, works better with LED light sources and all electronic low-voltage systems.

Operating temperature should be fine, but they need to be rated as a vapor sealed light fixture which I am not sure that they are. Seller or manufacturer should be able to answer that question for you. Also when installing make sure to place the lights less than 12” away from the wall as you want the lights to illuminate the sides of the steam sauna wall for the best illumination/effect.

Lights come with finger-like spring clips installed. If spring wires needed, merely remove single screw & nut mounting & swap spring types. These same screws allow spring to slide IN for 5" application & OUT for 6" application. Spring swaps & width adjustment takes no more than 2-3 minutes/light assembly.

No need to add anything to change the color temperature. There's a sliding switch on the rear of the lighting fixture with 5 indents for the different color temperatures. The switch can only be seen and accessible by sliding out the lights from the recessed cans.

Usually it's the quality of the electric components used in these LED light. The lower the wattage the lower the current needed due to the efficiency of the electrons moving throughout the fixture. Halo products cost more on average thus they are likely to have better and more efficient components to keep the wattage low yet maintain similar illumination.

Our spring clips are made of high-quality metal and have undergone rigorous testing before leaving the factory. Hence, they will work well during their lifespan. If your spring clips didn't work, feel free to contact us and we will offer you new spring clips immediately, free of charge! And we also offer clips if your cans are not the UL standard cans.
There is a slider on the back of the downlight, you can control the color by dragging the slider.

It will not, but it does not rule out the bulb damage caused by logistics. Please don't worry about the quality, we will provide the best service.

The beam angle of this bulb is 110 degree.

No, UL listed the bulbs are indoor use only.

5000K will make everything bright. It makes everything easy to see.

You have to purchase a dimmer light switch and install it. After that you can slide the switch up to control the light.

A19 bulb has a diameter of approximately 2.4 inches. In countries that use the metric system, A19 bulbs can also be called A60, where 60 refers to the diameter in millimeters.

It’s plastic shadow, but has metal inside.

Our A19 LED light bulbs are suitable for E26 medium base.

Please contact us freely with email, we will reply you in 24 hours with our best service.

Are these smooth on the Bulb end or do they have writing on them? Want them to be have no logo on the bulb as I have an open vanity light